We are pleased to introduce the MPA-M500NC a mono power amplifier based on a NCORE NC500MP amplification module . This unitis an affordable solution with formidable amplification power (up to 500W). It is suitable for any large listening room and for all projects requiring massive power.

The module is integrated in a robust 100% aluminum housing with vents. The latter has a simple design and excellent ability to block interference while effectively dissipating heat.

Amplification module NCORE NC500 MP

The Hypex NCORE NC500MP is a high efficiency 500W amplification circuit with low output impedance, low distortion and low noise. ll carry its own switching power supply unit with synchronous regulation.


As most of the amplifiers based on NCore, the frequency response is independent of the load and EMI are strictly controlled, which significantly limits the distortion.

All internal wiring connector uses OCC 2.5mm² conductors to enjoy excellent conductivity and preserve all of the signal subtleties.

Alternable input on RCA and XLR

The power amplifier has an RCA port input (mono) and a XLR input (balanced mono).

The RCA base is plated with gold 24k plastic and has a heat resistant capsule.

The XLR connector is a high quality Neutrik connector with metal latch and gold-plated conductors.

A two position switch toggles the XLR and RCA input with ease. This allow to connect two different preamps and alternate input sources.

High quality speaker terminals

Trigger 5-12V

A power trigger brings the comfort of an ignition sequence and allows a complete integration into your audio system.

The input power supply is a IEC14 socket. An angled power cable  3x1.5mm²- 1.8m is included for this purpose.

Audio Precision analysis data

Click here to see the performance measurements of NCORE NC500MP. (Opens a new tab)