BERRYBAK BEA 1 R2CEPTEUR BLUETOOTH
Excellent rapport qualité prix. Facile à installer , facile à mettre en route!
Excellent rapport qualité prix. Facile à installer , facile à mettre en route!
Nouveau client ?
Créez votre compte 0
0 Articles - 0,00 € Aucun produit
To be determined Frais de port
0,00 € Dont TVA
0,00 € Total
Les prix sont TTC
Quantité
Total
Produit ajouté avec succès à votre panier
Il y a 0 articles dans votre panier. Il y a 0 articles dans votre panier.
Total (TTC) :
Déjà vus
Avis clients
Note :
Date :
31/12/2024
Bruno C.
Note :
Date :
31/12/2024
Paulo A.
Excellent
This is a tiny, cheap pre amp phono that i bought to replace a broken NAD ... and it sound very very clear and cristal. For the...
This is a tiny, cheap pre amp phono that i bought to replace a broken NAD ... and it sound very very clear and cristal. For the...
Note :
Date :
31/12/2024
Paulo A.
Very good
I put this new tube in my Xduuo 605 amp and the sound is fantastic... very good. It's an huge upgrade from the original...
I put this new tube in my Xduuo 605 amp and the sound is fantastic... very good. It's an huge upgrade from the original...
NEOTECH NEX-OCC GD Connecteurs XLR Mâle / Femelle 3 Pôles Cuivre UP-OCC Plaqués Or Ø13mm (Set x4) - avis - Il y a 4 avis.
Seuls les utilisateurs enregistrés peuvent poster un avis. Connectez-vous ou créez un compte .
Note :
Date :
23/06/2022
Timo T.
Note :
Date :
28/04/2020
Jan K.
Note :
Date :
21/09/2019
Harry W.
The sound of these connectors are perfect. I would have given five Stars if there weren’t some annoying design flaws, such as;
• Plastic melts very fast, Teflon or PEEK would have been better.
• There aren't air venting holes in soldering tubes. Solder Tin bubbles out of the tube when soldering.
• Soldering tube Pin 1 is very small. Twisted shield wire does not fit.
• Cable clamp is of a poor design. All around clamping would have been better.
• Plastic melts very fast, Teflon or PEEK would have been better.
• There aren't air venting holes in soldering tubes. Solder Tin bubbles out of the tube when soldering.
• Soldering tube Pin 1 is very small. Twisted shield wire does not fit.
• Cable clamp is of a poor design. All around clamping would have been better.
Français 
English 
